Skip to content

Production Control

Your tank fills itself, and you see it on your phone.

It measures the water going into the tank, turns the pump on when the level drops and off when it reaches the level you set. From your dashboard you see how much water there is, how much came in and why the pump is or isn’t filling.

Stop · 95%Start · 80%72%PumpFlow sensor18 L/min coming in
Illustration. The percentages are the factory defaults; you change them from your dashboard.

How it works

  1. Install it on the inlet

    The flow sensor goes on the pipe that fills the tank, and the relay on the fill pump.

  2. Give it Wi‑Fi from your phone

    It opens its own network: you pick your Wi‑Fi from a list and it’s saved. No laptop or cable.

  3. Set your levels

    From your dashboard you choose the level where it starts and where it stops, in liters or as a percentage of the tank.

What it does

The device already does all of this, with nobody needing to be at the plant.

Fills itself

  • Turns the pump on when the level drops below the start level and off when it reaches the stop level.
  • Both levels are set from your dashboard, in liters or as a percentage of the tank.
  • From the dashboard you can also turn it on, off or leave it on automatic, and the command arrives in seconds.
  • Counts the liters coming in with a flow sensor that is calibrated on site.

Protects the pump even when nobody is watching

  • If the pump turns on and no water comes in within a minute, it shuts it off and locks out.
  • If a fill takes longer than normal, it also shuts it off and locks out.
  • Every fill has a liter limit, even if the internet drops halfway through.
  • The lockout survives a power outage: it’s released on the device, after someone checks.

Alerts you

  • An alert when the tank drops below 20% and a critical alert below 10%, on your dashboard and on WhatsApp if you turn it on.
  • On your dashboard you see why the pump isn’t filling: no water came in, the maximum time passed, or the level has been low for a while without pumping.
  • If the device stops reporting, the tank is marked “No signal”.

Always connected

  • Reports the level, the liters that came in and the flow rate every minute.
  • Keeps your previous network as a backup and switches by itself if the main one won’t connect.
  • If it goes 10 minutes without internet, it opens its own network again so you can give it another one.

Frequently asked questions

What happens if the internet goes down?

A fill that already started finishes with its safety cutoffs and its liter limit. Automatic start waits for a recent level reading, so it never turns the pump on blind.

Do I need a laptop to install it?

No. It connects to the internet from your phone: it opens its own network and you pick your Wi‑Fi from a list.

Can I change the levels later?

Yes, from your dashboard, whenever you want. The device picks them up in seconds and won’t let you set a start level above the stop level.

Can I see it before buying?

Yes. The demo has tanks with their levels, fills and alerts, with no sign-up or card.

Keep your tank from running dry.

Message us and we’ll tell you how to install it at your plant.